Metamaterial-Inspired-Square Ring Resonator Structure using MIMO Antenna for Multi band Wireless Communication Networks and Fifth Generation Applications

Authors

  • M. Rajakumar, M. Meena, V. Rajendran

Keywords:

Monopoles antenna, Wireless applications, Metamertial, Isolation, 5G.

Abstract

A Metmaterial construction is to reduce the mutual coupling between the closely spaced microstirp patch antenna elements is given in this research.  The proposed antenna two monopoles of various sizes are place in parallel with stub 3.5mm thickness    used for good impedance. An electrically thin substrate was coupled by a parallel line, and the feed was connected to a tuning stub. MIMO antenna consisting of two port components is positioned in parallel to one another, with an edge to edge spacing of (6mm) maintain the meta material structure between the MIMO Parts results in a10 dB increase the isolation. About -28 dB of isolation is attained with the suggested configuration. The suggested antenna is a strong contender for MIMO applications because of its low ECC, high gain, minimal channel capacity loss, and extremely low mutual coupling between components. Proposed system has the following advantages: low profile, broad bandwidth, high gain (>8 dB), improved isolation (28 dB), low channel capacity loss (CCL) (<0.05) and envelope correlation coefficient (<0.0001), as well as high diversity gain (DG) (>9.99 dB). Good agreement is found between the simulated and measured data, confirming the system performance experimentally. These characteristics highlight the system's suitability for 5G wireless networks.

Downloads

Download data is not yet available.

References

M. Abbosh and M. E. Bialkowski, “Design of UWB planar band-notched antenna using parasitic elements,” IEEE Transactions on Antennas and Propagation, vol. 57, pp. 796– 799, 2009.

H. Medkour, M. Cheniti, A. Narbudowicz et al., “Coplanar waveguide-based ultra-wide band antenna with switchable filtering of WiMAX 3.5 GHz and WLAN 5 GHz signals,” Microwave and Optical Technology Letters, vol. 62, no. 6, pp. 2398–2404, 2020.

Gorai and R. Ghatak, “Multimode resonator-assisted dual band notch UWB antenna with additional bluetooth resonance characteristics,” IET Microwaves, Antennas & Propagation,vol. 13, pp. 1854–1859, 2019.

R. Mondal, P. S. Reddy, D. C. Sarkar, and P. P. Sarkar,“Compact ultra-wideband antenna: improvement of gain and FBR across the entire bandwidth using FSS,” IET Microwaves, Antennas & Propagation, vol. 14, no. 1, pp. 66–74, 2020.

M. S. Khan, A. D. Capobianco, A. Naqvi, M. F. Shafique, B. Ijaz, and B. D. Braaten, “Compact planar UWB MIMO antenna with on-demand WLAN rejection,” Electronics Letters, vol. 51, no. 13, pp. 963-964, 2015.

R. Azim, M. T. Islam, and A. T. Mobashsher, “Design of a dual band-notch UWB slot antenna by means of simple parasitic slits,” IEEE Antennas and Wireless Propagation Letters, vol. 12, pp. 1412–1415, 2013.

Sharma and M. M. Sharma, “An UWB antenna design with dual band notched characteristic using U-shaped slots,” in Proceedings of the IEEE International Conference on Signal Processing and Communication, Noida, India, December 2016.

R. Azeez, T. A. Elwi, and Z. A. Abed Al-Hussain, “Design and analysis of a novel concentric rings based crossed lines single negative metamaterial structure,” Engineering Science and Technology, An International Journal, vol. 20, no. 3, pp. 1140–1146, 2017.

J. B. Pendry, A. J. Holden, D. J. Robbins, and W. J. Stewart,“Magnetism from conductors and enhanced nonlinear phenomena,”IEEE Transactions on Microwave 4eory and Techniques, vol. 47, no. 11, pp. 2075–2084, 1999.

X. Zhang, T.-L. Zhang, Y.-Y. Xia, Z.-H. Yan, and X.-M. Wang,“Planar monopole antenna with band-notch characterization for UWB applications,” Progress in Electromagnetics Research Letters, vol. 6, pp. 149–156, 2009.

Babu, K.V.; Das, S.; Sree, G.N.J.; Patel, S.K.; Saradhi, M.P.; Tagore, M. Design and development of miniaturized MIMO antenna using parasitic elements and Machine learning (ML) technique for lower sub 6 GHz 5G applications. AEU-Int. J. Electron. Commun. 2022, 153, 154281.

Xiong, H.Q.; Zhang, C.J.; Tong, M.S. Wideband Low-Profile Dual-Polarized Antenna Based on a Gain-Enhanced EBG Reflector. IEEE Trans. Compon. Packag. Manuf. Technol. 2021, 12, 391–394.

Khan, A.; Bashir, S.; Ghafoor, S.; Qureshi, K.K. Mutual coupling reduction using ground stub and EBG in a compact wideband MIMO-antenna. IEEE Access 2021, 9, 40972–40979.

Yang, R.; Xi, S.; Cai, Q.; Chen, Z.; Wang, X.; Liu, G. A compact planar dual-band multiple-input and multiple-output antenna with high isolation for 5G and 4G applications. Micromachines 2021, 12, 544.

Wang, Z.; Li, C.; Wu, Q.; Yin, Y. A metasurface-based low-profile array decoupling technology to enhance isolation in MIMO antenna systems. IEEE Access 2020, 8, 125565–125575.

Panda, P.K.; Ghosh, D. Isolation and gain enhancement of patch antennas using EMNZ superstrate. AEU-Int. J. Electron. Commun.2018, 86, 164–170.

Downloads

Published

12.06.2024

How to Cite

M. Rajakumar. (2024). Metamaterial-Inspired-Square Ring Resonator Structure using MIMO Antenna for Multi band Wireless Communication Networks and Fifth Generation Applications. International Journal of Intelligent Systems and Applications in Engineering, 12(4), 2413 –. Retrieved from https://www.ijisae.org/index.php/IJISAE/article/view/6649

Issue

Section

Research Article